So your touch sensor is not working?

sensorWe have all experienced it, you buy something at Aliexpress. It arrives and you confirm receipt before you have time to test everything and then when you finally get around to that… there is a problem.
That happened to me with a TTP223B capacitive touch sensor. Whatever I tried, the output remained low. Slightly frustrated I was looking at the rather simple board and thought that there really couldn’t be much wrong with it.
ttp223-icFound a datasheet of the TTP223B ic that is on this module and started measuring. Well to make a long story short, the input pin (pin 3) seemed to have no connection with the sensorplate. When I would just touch the input pin, it switched very well. According to an application note in the datasheet capacitor C1 should be between  the input and  the ground and as it should be connected it also should be connected to the  sensorplate, which in fact it was. Turns out pin 3 was not connected to anything. A small wire that I soldered between the top of C1 and  pin 3 remedied everything and after that the sensor worked wonder well.
On checking the feedback of people who ordered this sensor, I noticed many experienced the same problem. No doubt the manufacturer (not perse the seller) must have known about this.

ttp233

15 thoughts on “So your touch sensor is not working?”

  1. Do not matter if manufacturer know about this bug or not. I am sure, that seller got many of these boards and he will sell them, do not matter if it has bug or not.

    BTW you can add additional feedback on aliexpress for circa 6 months and open case 15 days after confirmation…

    regards

  2. Dear Mr Arduino. I’d like to ask you some question about my project thats using peltier, i just have a thought that you might be able to help me. Could i get your email maybe? or any other way i can contact you, since i can’t attach any picture here to help you understand my problem. Iam a student in a polytechnic and last year, you already help me a lot with my final project by replying my comment on this website on your “Arduino Dimmer” tutorial. Thank you so much for that and please reply me :))

    1. That seems to be the same on that I had and that was fAulty. Is it perhaps close to a metal surface? Try a 100nf capacitor o er the vcc and ground of the module

  3. hiii sir Iam trying to interface the touch sensor with Arduino Uno it’s working but I don’t know it was automatically turned on and off I don’t know please anybody give some suggestions about touch sn sensors thank you.

    1. I am not exactly sure what it is you are asking. The touch sensor in yr link has a vcc, a ground and a signal pin, clearly indicated on the pcb. Vcc and ground go to the corresponding pins of the arduino and the signal pin to a digital pin of the uno

  4. I want to interface the heart rate ecg module to Arduino nano I tried to interface the connection but the plot in serial monitoring was displays only one minute otherwise it was not working , please give solution to draw the plot in continuous plotting for ecg module thank you.

    1. That is a totally unrelated question. The plotting usually is not done by the arduino in the serial monitor but by a program getting data from the serial afaik

Leave a Reply to Arduino Cancel reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.