Microphone pre-amp for microcontrollers


This microphone amplifier is based arond the TLC272 double opamp.
The first opamp is  used as an amplifier. The voltage offset on the positive input is set to half Vcc with R2 and R3. The Closedloop gain is set at 100 by R5 and R4. There is an AC coupling/high pass filter to the 2nd opamp by C4 and R6. The second opamp is used as comparator: R7 and R8 determine a level sensitivity of 71 mV (with 5 Volt Vcc).

SPL is the sound pressure level. There is also an audio output for the amplified microphone signal. As the audio signal is DC coupled, the signal will swing around 1/2 Vcc

Microphone pre-amp for Arduino
Note: In the picture you may see a TL072 chip rather than a TS272 (TLC272). That is because I briefly tried that one. The TL072 is a double opamp especially for audio purposes. My results with it however were not so convincing. Best use the TS272 (TLC272)


Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.